However if you have to use software RAID then you need to add software raid drivers in WinPE image as described in above mentioned article. Again – we do not recommend using software RAID controllers (even the windows utility) because you then need the software running in the recovery environment in order to see the array, which can be problematic.You can read more about adding drivers at different steps in this article. MacDrive also didn’t seem to do anything Paragon HFS+ couldn’t and it was only 20. MacDrive feels a bit too heavy on the marketing speak.

Paragon actually sells a bundle with Paragon NTFS for macOS and some other tools for not much more than MacDrive. You cannot add drivers to Linux based recovery media because it is hard-coded for hardware support. MacDrive is a bit flashy and more than twice as expensive as Paragon HFS+. Locate manufacture and make sure Seagate is listed like the example below: HFS+ Troubleshooting Installing the Paragon HFS+ driver will give you the ability to see your HFS+ formatted drive. If you installed drivers for your SATA/RAID controller, then you will need to add drivers during WinPE creation or after you load in WinPE environment (Load Drivers Wizard). Seagate Paragon Driver For Mac Review In the middle locate your Seagate drive - Select it. If you have built into your motherboard Intel based SATA/RAID controller and you do not need any windows drivers to use/see it (you would have needed to load drivers when installing windows) you should not need to load driver’s in the recovery environment – just create WinPE and boot from it.File System Driver (FSD) products for Mac (such as NTFS for Mac and ExtFS for Mac) should work with RAID volumes if it’s supported and detected correctly by OS X.

Paragon driver for mac reviews